BMW - 2.8 - 193-BHP - 144-KW
Estimated %30 more power and %40 more torque
Parameters | Original | Stage 1 | Stage 2 |
---|---|---|---|
Power (Hp) | 193 | 206 | 227 |
Torque (Nm) | 245 | 270 | 297 |
Vehicle Information
Vehicle: cars |
Brand: BMW |
Year: (01/1991 - 01/2000) |
Model: 328i |
Fuel: Petrol |
Engine: 2.8 - 193-BHP - 144-KW |
Chip Tuning: M52B28 |
Ecu Information
Engine Ecu: SIEMENS MS41 |
Reading Devices: Behind panel, above pedals |
OBD: ENU_144300K202 |
Reading Devices
KESSV2: OBD |
Kess V2 Protocollo: 145 |
Processore KTAG: Not yet supported - Check tool |
AUTOTUNER: Not yet supported - Check tool |
X17: Not yet supported - Check tool |
CMD: OBD/Boot/Bench |
Available Solutions
DPF: NO | EGR: NO |
ADBLUE: NO | TVA: NO |
HOT START: NO | SAP: NO |
DTC: NO | EVAP: NO |
HARDCUT: NO | POP & BANG: NO |
EXAUST FLAP: NO | GPF OFF: NO |
TQM: NO | SPEED LIMIT: YES |
START STOP: NO | LAMBDA: NO |
MAF: NO | BOOST SENSOR: NO |
SPORT DISPLAY: NO | SWIRL FLAP: NO |
LAUNCH CONTROL: YES |
Note 1
If push button ignition please follow these steps. 1. hold button for 4 seconds and release. Dash should illuminate, if it doesn?t press once more. Onnce dash illuminated proceed to read/write. When kess prompts to cycle ignition just ignore and select next. Without doing this will still read but fail on write