BMW - 2.5 - 231-BHP - 172-KW
Estimated %30 more power and %40 more torque
| Parameters | Original | Stage 1 | Stage 2 |
|---|---|---|---|
| Power (Hp) | 231 | 251 | 276 |
| Torque (Nm) | 300 | 320 | 352 |
Vehicle Information
| Vehicle: cars |
| Brand: BMW |
| Year: (01/1999 - 01/2003) |
| Model: 330i Coupe |
| Fuel: Petrol |
| Engine: 2.5 - 231-BHP - 172-KW |
| Chip Tuning: M54B30 |
Ecu Information
| Engine Ecu: SIEMENS MS43 |
| Reading Devices: Behind panel, above pedals |
| OBD: ENU_094300CAN1 |
Reading Devices
| KESSV2: OBD |
| Kess V2 Protocollo: 59 |
| Processore KTAG: Not yet supported - Check tool |
| AUTOTUNER: Not yet supported - Check tool |
| X17: Not yet supported - Check tool |
| CMD: OBD/Boot/Bench |
Available Solutions
| DPF: NO | EGR: NO |
| ADBLUE: NO | TVA: NO |
| HOT START: NO | SAP: NO |
| DTC: NO | EVAP: NO |
| HARDCUT: NO | POP & BANG: YES |
| EXAUST FLAP: NO | GPF OFF: NO |
| TQM: NO | SPEED LIMIT: YES |
| START STOP: NO | LAMBDA: YES |
| MAF: NO | BOOST SENSOR: NO |
| SPORT DISPLAY: NO | SWIRL FLAP: NO |
| LAUNCH CONTROL: NO |
Note 1
If push button ignition please follow these steps. 1. hold button for 4 seconds and release. Dash should illuminate, if it doesn?t press once more. Onnce dash illuminated proceed to read/write. When kess prompts to cycle ignition just ignore and select next. Without doing this will still read but fail on write
