BMW - 3.0 - 272-BHP - 203-KW
Estimated %30 more power and %40 more torque
Parameters | Original | Stage 1 | Stage 2 |
---|---|---|---|
Power (Hp) | 272 | 282 | 310 |
Torque (Nm) | 300 | 337 | 371 |
Vehicle Information
Vehicle: cars |
Brand: BMW |
Year: (01/2006 - 01/2010) |
Model: X3 |
Fuel: Petrol |
Engine: 3.0 - 272-BHP - 203-KW |
Chip Tuning: N52B30O1 |
Ecu Information
Engine Ecu: SIEMENS MSV80 |
Reading Devices: Kick panel, driver's side |
OBD: ENU_MO_0202 |
Reading Devices
KESSV2: OBD |
Kess V2 Protocollo: 202 |
Protocollo KTAG: 990 |
Processore KTAG: Boot(Tricore) |
AUTOTUNER: Not yet supported - Check tool |
X17: OBD/Boot/Bench |
CMD: OBD/Boot/Bench |
Available Solutions
DPF: NO | EGR: NO |
ADBLUE: NO | TVA: NO |
HOT START: NO | SAP: NO |
DTC: NO | EVAP: YES |
HARDCUT: NO | POP & BANG: YES |
EXAUST FLAP: NO | GPF OFF: NO |
TQM: NO | SPEED LIMIT: YES |
START STOP: NO | LAMBDA: YES |
MAF: NO | BOOST SENSOR: NO |
SPORT DISPLAY: NO | SWIRL FLAP: NO |
LAUNCH CONTROL: NO |
Note 1
If push button ignition please follow these steps. 1. hold button for 4 seconds and release. Dash should illuminate, if it doesn?t press once more. Onnce dash illuminated proceed to read/write. When kess prompts to cycle ignition just ignore and select next. Without doing this will still read but fail on write