Renault - 1.2 - 100-BHP - 75-KW
Estimated %30 more power and %40 more torque
| Parameters | Original | Stage 1 | Stage 2 |
|---|---|---|---|
| Power (Hp) | 100 | 125 | 138 |
| Torque (Nm) | 155 | 200 | 220 |
Vehicle Information
| Vehicle: cars |
| Brand: Renault |
| Year: (01/2009 - 01/2012) |
| Model: Clio Sport Tourer |
| Fuel: Petrol |
| Engine: 1.2 - 100-BHP - 75-KW |
| Chip Tuning: TCEGT |
Ecu Information
| Engine Ecu: SIEMENS SIM32 |
| Reading Devices: Below heater controls |
| OBD: ENU_094300CAN1 |
Reading Devices
| KESSV2: OBD |
| Kess V2 Protocollo: 123 |
| Kess V2 Aiuto: ENU_L_0252 |
| Protocollo KTAG: 252 |
| KTAG Aiuto: ENU_L_0252 |
| Processore KTAG: Jtag(Renesas) |
| AUTOTUNER: Not yet supported - Check tool |
| X17: Not yet supported - Check tool |
| CMD: OBD Only |
Available Solutions
| DPF: NO | EGR: NO |
| ADBLUE: NO | TVA: NO |
| HOT START: NO | SAP: NO |
| DTC: NO | EVAP: NO |
| HARDCUT: NO | POP & BANG: NO |
| EXAUST FLAP: NO | GPF OFF: NO |
| TQM: NO | SPEED LIMIT: YES |
| START STOP: NO | LAMBDA: NO |
| MAF: NO | BOOST SENSOR: NO |
| SPORT DISPLAY: NO | SWIRL FLAP: NO |
| LAUNCH CONTROL: NO |
Note 1
Clean surface of probe points well, if not reading/writing clean again
Note 2
On keyless, put card in slot, into first gear and push button for 10 seconds until 'Remove card' comes up on dash
