Renault - 2.0 - 220-BHP - 164-KW
Estimated %30 more power and %40 more torque
Parameters | Original | Stage 1 | Stage 2 |
---|---|---|---|
Power (Hp) | 220 | 300 | 330 |
Torque (Nm) | 340 | 440 | 484 |
Vehicle Information
Vehicle: cars |
Brand: Renault |
Year: (01/2014 - 01/2016) |
Model: Megane Coupe |
Fuel: Petrol |
Engine: 2.0 - 220-BHP - 164-KW |
Ecu Information
Engine Ecu: SAGEM S3000 |
: Sealed all around, remove one side select |
Reading Devices: Behind panel, below radio |
OBD: ENU_MO_0090 |
Reading Devices
KESSV2: OBD |
Kess V2 Protocollo: 90 |
Kess V2 Aiuto: ENU_L_0250 |
Protocollo KTAG: 250 |
KTAG Aiuto: ENU_L_0250 |
Processore KTAG: Jtag(Renesas) |
AUTOTUNER: Not yet supported - Check tool |
X17: OBD Only |
CMD: OBD Only |
Available Solutions
DPF: NO | EGR: NO |
ADBLUE: NO | TVA: NO |
HOT START: NO | SAP: NO |
DTC: NO | EVAP: NO |
HARDCUT: NO | POP & BANG: NO |
EXAUST FLAP: NO | GPF OFF: NO |
TQM: NO | SPEED LIMIT: YES |
START STOP: NO | LAMBDA: YES |
MAF: NO | BOOST SENSOR: NO |
SPORT DISPLAY: NO | SWIRL FLAP: NO |
LAUNCH CONTROL: NO |
Note 1
Clean surface of probe points well, if not reading/writing clean again
Note 2
On keyless, put card in slot, into first gear and push button for 10 seconds until 'Remove card' comes up on dash