Renault - 1.6 - 110-BHP - 82-KW
Estimated %30 more power and %40 more torque
| Parameters | Original | Stage 1 | Stage 2 |
|---|---|---|---|
| Power (Hp) | 110 | 124 | 136 |
| Torque (Nm) | 152 | 171 | 188 |
Vehicle Information
| Vehicle: cars |
| Brand: Renault |
| Year: (01/2013 - 01/2016) |
| Model: Scenic |
| Fuel: Petrol |
| Engine: 1.6 - 110-BHP - 82-KW |
Ecu Information
| Engine Ecu: SAGEM S3000 |
| : Sealed all around, remove one side select |
| Reading Devices: Below cup holder |
| OBD: ENU_MO_0090 |
Reading Devices
| KESSV2: OBD |
| Kess V2 Protocollo: 90 |
| Kess V2 Aiuto: ENU_L_0250 |
| Protocollo KTAG: 250 |
| KTAG Aiuto: ENU_L_0250 |
| Processore KTAG: Jtag(Renesas) |
| AUTOTUNER: Not yet supported - Check tool |
| X17: OBD Only |
| CMD: OBD Only |
Available Solutions
| DPF: NO | EGR: NO |
| ADBLUE: NO | TVA: NO |
| HOT START: NO | SAP: NO |
| DTC: NO | EVAP: NO |
| HARDCUT: NO | POP & BANG: NO |
| EXAUST FLAP: NO | GPF OFF: NO |
| TQM: NO | SPEED LIMIT: YES |
| START STOP: NO | LAMBDA: YES |
| MAF: NO | BOOST SENSOR: NO |
| SPORT DISPLAY: NO | SWIRL FLAP: NO |
| LAUNCH CONTROL: NO |
Note 1
Clean surface of probe points well, if not reading/writing clean again
Note 2
On keyless, put card in slot, into first gear and push button for 10 seconds until 'Remove card' comes up on dash
