Volvo - 1.6 TD - 109-BHP - 81-KW
Estimated %30 more power and %40 more torque
| Parameters | Original | Stage 1 | Stage 2 |
|---|---|---|---|
| Power (Hp) | 109 | 140 | 154 |
| Torque (Nm) | 240 | 300 | 330 |
Vehicle Information
| Vehicle: cars |
| Brand: Volvo |
| Year: (01/2006 - 01/2009) |
| Model: C30 |
| Fuel: Diesel |
| Engine: 1.6 TD - 109-BHP - 81-KW |
| Chip Tuning: D4164T |
Ecu Information
| Engine Ecu: BOSCH EDC16C34 |
| : Sealed all around, remove one side |
| Reading Devices: Above pedals |
| OBD: ENU_MO_0488 |
Reading Devices
| KESSV2: OBD |
| Kess V2 Protocollo: 488 |
| Kess V2 Aiuto: ENU_L_EDC16 |
| Protocollo KTAG: 66 |
| KTAG Aiuto: ENU_L_EDC16 |
| Processore KTAG: Bdm(MPC5xx) |
| AUTOTUNER: Not yet supported - Check tool |
| X17: Boot Only |
| CMD: BDM |
Available Solutions
| DPF: YES | EGR: YES |
| ADBLUE: NO | TVA: YES |
| HOT START: NO | SAP: NO |
| DTC: YES | EVAP: NO |
| HARDCUT: NO | POP & BANG: NO |
| EXAUST FLAP: NO | GPF OFF: NO |
| TQM: NO | SPEED LIMIT: YES |
| START STOP: NO | LAMBDA: NO |
| MAF: NO | BOOST SENSOR: NO |
| SPORT DISPLAY: NO | SWIRL FLAP: YES |
| LAUNCH CONTROL: NO |
Note 1
A canbus Uxxxx code can be displayed on the scantool after the remap relating to "Internal Control Module Software Incompatibility/Control Module, faulty software checksum ECM". Unfortunately there is no fix for this. This will not trigger a mil code nor trigger limp mode, its a background code to mark to Volvo the ECU has been remapped.
Note 2
144300K264 Volvo cable required for Kess V2
