Volvo - 2.0 D3 EU5 - 150-BHP - 112-KW
Estimated %30 more power and %40 more torque
| Parameters | Original | Stage 1 | Stage 2 |
|---|---|---|---|
| Power (Hp) | 150 | 200 | 220 |
| Torque (Nm) | 350 | 450 | 495 |
Vehicle Information
| Vehicle: cars |
| Brand: Volvo |
| Year: (01/2012 - 01/2016) |
| Model: V40 |
| Fuel: Diesel |
| Engine: 2.0 D3 EU5 - 150-BHP - 112-KW |
| Chip Tuning: D5204T6 |
Ecu Information
| Engine Ecu: BOSCH EDC17CP48 |
| : Sealed all around, remove one side |
| Reading Devices: Above pedals |
| OBD: ENU_MO_0638 |
Reading Devices
| KESSV2: OBD - After K-Tag unlock |
| Kess V2 Protocollo: 638 |
| Kess V2 Aiuto: ENU_EDC17_VOLVO_TPROT |
| Protocollo KTAG: 681 |
| KTAG Aiuto: ENU_EDC17_VOLVO_TPROT |
| Processore KTAG: Boot(Tricore) |
| AUTOTUNER: Boot/Bench |
| X17: Boot/Bench |
| CMD: Boot/Bench |
Available Solutions
| DPF: YES | EGR: YES |
| ADBLUE: NO | TVA: NO |
| HOT START: NO | SAP: NO |
| DTC: YES | EVAP: NO |
| HARDCUT: NO | POP & BANG: NO |
| EXAUST FLAP: NO | GPF OFF: NO |
| TQM: YES | SPEED LIMIT: YES |
| START STOP: NO | LAMBDA: NO |
| MAF: NO | BOOST SENSOR: NO |
| SPORT DISPLAY: NO | SWIRL FLAP: YES |
| LAUNCH CONTROL: NO |
Note 1
A canbus Uxxxx code can be displayed on the scantool after the remap relating to "Internal Control Module Software Incompatibility/Control Module, faulty software checksum ECM". Unfortunately there is no fix for this. This will not trigger a mil code nor trigger limp mode, its a background code to mark to Volvo the ECU has been remapped.
